The sterilization principle of microwave electrodeless ultraviolet sterilization equipment is to use the sterilization ability of ultraviolet light. Can ultraviolet light directly kill microorganisms? Microwave food sterilization manufactor According to different biological effects, ultraviolet light is generally divided into four parts according to wavelength: A-band (UV-A), new type Microwave food sterilization Also known as black spot effect ultraviolet (400 ～ 320 nm); B band (UV-B), also known as erythema effect ultraviolet (320 ～ 275 nm); C-band (UV-C), also known as sterilization ultraviolet (275 ～ 200 nm); D-band (UV-D), also known as vacuum ultraviolet ray (200-100 nm). C-band ultraviolet light is mainly used for water disinfection.

The microwave ultraviolet water treatment equipment uses quartz sand filter material to remove the suspended solids, sediment, impurities, etc. of larger particles in the raw water and the turbidity of precipitation. In addition, it can also remove organic substances, bacteria, x, etc. in the water along with the decrease of turbidity, and create good conditions for disinfection after filtration. new type Microwave food sterilization Use the adsorption capacity of activated carbon to effectively adsorb organic matter, free residual chlorine, colloid, particles, microorganisms Microwave food sterilization manufactor For some metal ions and decolorization, the exchange function of ion resin is used to remove calcium and magnesium ions in raw water to avoid the impact of scaling on subsequent equipment. However, the operation is laborious and material consuming. Now, the dosing system is used to directly add scale inhibitor.

The trapezoidal structure made of food grade transparent silica gel and special mold is used to prevent water leakage caused by improper installation. Microwave food sterilization manufactor UV irradiation intensity sensor/UV irradiation intensity monitor: The UV irradiation intensity sensor can monitor the output intensity of the UV disinfection system in real time online, and output mixed signals of 0-5V or 4-20mA for use by the monitor. new type Microwave food sterilization The ultraviolet radiation intensity monitor receives the signal provided by the sensor, and can set the radiation intensity alarm value and lamp life according to the requirements. Monitor the system in real time to ensure the normal operation of the equipment.

1. If linear installation is required, please use the installation method of low water inlet and high water outlet to slow down the water flow rate and increase the effect of ultraviolet radiation. 2. When working, Microwave food sterilization manufactor Do not look directly into your eyes with an ultraviolet lamp. When the equipment is open, repeated opening and closing will seriously affect the service life of the lamp. 3. If the water flow is too fast, please install current limiting and pressure limiting devices. 4. If the turbidity of raw water exceeds 5 degrees, a prefilter should be installed to ensure ultraviolet sterilization. 5. Please take out the quartz sleeve every time. new type Microwave food sterilization After using the disinfection lamp for two to three months, check the surface for dirt to determine the next time to clean the surface of the quartz sleeve.