Microwave electrodeless ultraviolet sterilization equipment Attention shall be paid to:

1. If linear installation is required, please use the installation method of low water inlet and high water outlet to slow down the water flow rate and increase the effect of ultraviolet radiation.

2. When working, please do not look directly into your eyes and use the ultraviolet lamp. When the equipment is open, repeated opening and closing will seriously affect the service life of the lamp.

3. If the water flow is too fast, please install current limiting and pressure limiting devices.  

4. If the turbidity of raw water exceeds 5 degrees, a prefilter should be installed to ensure ultraviolet sterilization.

5. Please take out the quartz sleeve every time. After using the disinfection lamp for two to three months, check the surface for dirt to determine the next time to clean the surface of the quartz sleeve.

When selecting microwave Electrodeless ultraviolet sterilization equipment There are different wave bands to choose from. It is recommended to choose the disinfector in the deep ultraviolet wave band. Because the deep ultraviolet wave band has a wider sterilization range and stronger sterilization ability.

In addition, when using the disinfector in the deep ultraviolet wave band, we must pay attention to the radiation dose and time. If the irradiation dose is not enough or the time is too short, there is no way to achieve the expected sterilization effect.