1. If linear installation is required, please use the installation method of low water inlet and high water outlet to slow down the water flow rate and increase the effect of ultraviolet radiation. 2. When working, Microwave extraction equipment manufactor Do not look directly into your eyes with an ultraviolet lamp. When the equipment is open, repeated opening and closing will seriously affect the service life of the lamp. 3. If the water flow is too fast, please install current limiting and pressure limiting devices. 4. If the turbidity of raw water exceeds 5 degrees, a prefilter should be installed to ensure ultraviolet sterilization. 5. Please take out the quartz sleeve every time. new type Microwave extraction equipment After using the disinfection lamp for two to three months, check the surface for dirt to determine the next time to clean the surface of the quartz sleeve.

Compared with traditional water disinfection methods such as chlorine disinfection, new type Microwave extraction equipment Microwave electrodeless ultraviolet sterilization equipment is relatively safe and environmentally friendly. Chlorine agent is used for disinfection. When chlorine kills germs in water, due to its strong oxidation, it reacts with natural organic substances in water and generates disinfection by-products such as trichloromethane and haloacetic acid, Microwave extraction equipment manufactor They all have potential carcinogenicity and certain mutagenicity to human body. Trichloromethane is also classified as Category 2B carcinogen in the list of carcinogens published by the International Cancer Research Institute of the World Health Organization, which poses a health threat of carcinogenicity, teratogenicity and mutagenicity.

When microwave ultraviolet water treatment equipment is used, the construction of all equipment must be understood according to the relevant drawings or manufacturing technology, even before the equipment is used, new type Microwave extraction equipment Basically, the installation shall be carried out according to the relevant works, and the design shall be carried out according to the size of the whole casing or the relevant actual use needs, the soil of reinforced concrete and other embedded parts, Microwave extraction equipment manufactor It is also necessary to do a good job in relevant design, and their size and location should meet the design requirements. In the actual treatment process of microwave and ultraviolet water treatment equipment, there will be various processes of construction or acceptance. Of course, as long as the installation of some machinery or other pipeline construction is involved, the welding process will be more or less controlled, and they should refer to the relevant design regulations, Or other standards and related technologies can be used cooperatively.

In the microwave and ultraviolet water treatment equipment, the reverse osmosis equipment needs three kinds of sealing rings to realize the sealing barrier of each part of the membrane shell. In order to reduce the resistance of the device, water or glycerin should be added to the surface of the sealing ring. new type Microwave extraction equipment Microwave ultraviolet water treatment equipment PP cotton softening equipment. Microwave extraction equipment manufactor Special attention should be paid to the use of petroleum jelly or other petroleum grease lubricants as lubricants. Otherwise, the fresh water pipeline will crack, especially the expansion of the sealant ring. The expansion of the skirt does not directly affect the operation of the system, but will affect the reloading of the system after unloading, that is, the expansion skirt is difficult to enter the slot during loading.