The technology of microwave ultraviolet water treatment equipment is to use double layer ultrafiltration membrane for microwave ultraviolet water treatment equipment, or combine ultrafiltration membrane and reverse osmosis filtration membrane for application. Breeding sterilization and disinfection equipment manufactor When the manufacturer of microwave ultraviolet water treatment equipment applies external pressure on the concentrated solution side, the penetration speed will decrease. When the pressure increases to a certain value, the penetration process will stop and the so-called penetration balance will be reached. The external pressure under the balance condition is called the penetration pressure. When the pressure on the concentrated solution side continues to increase, that is, when the applied pressure is greater than the penetration pressure, The solvent of purified water equipment will reverse its original soaking direction and enter the dilute solution side from the concentrated solution side through the semi permeable membrane, Customized Breeding sterilization and disinfection equipment This phenomenon is called reverse osmosis. For a long time, it will not only affect the effluent quality of the equipment, but also lead to the fouling of the reverse osmosis membrane of the main components of the equipment, resulting in the small output of the pure water equipment, the substandard effluent quality, or the equipment can not be used. In order to ensure the continuous and safe operation of pure water equipment, the maintenance of pure water equipment is very important.

When choosing microwave electrodeless ultraviolet sterilization equipment, there are different wave bands to choose from, Customized Breeding sterilization and disinfection equipment It is recommended to select disinfector with deep ultraviolet wave band. Because the deep ultraviolet wave band has a wider sterilization range and stronger sterilization ability. Breeding sterilization and disinfection equipment manufactor In addition, when using the disinfector in the deep ultraviolet wave band, we must pay attention to the radiation dose and time. If the irradiation dose is not enough or the time is too short, there is no way to achieve the expected sterilization effect.

Swimming and playing other water sports are exciting ways, Customized Breeding sterilization and disinfection equipment You can relax and exercise at the same time! Some sunshine, physical exercise and laughter all advocate a healthy life. You can spend endless time in the water with your friends and family, but it is responsible to enjoy the fun in the carefree sunshine. A healthy swimming pool is not only visually clean, but also has proper chemical balance, Breeding sterilization and disinfection equipment manufactor These chemical balances should not overwhelm your senses. If you like swimming pools, you will hear about bacteria such as Giardia, Cryptosporidium and Legionella. Installing an ultraviolet sterilizer will eliminate the bacteria and parasites that cause these diseases, and keep your swimming pool water clear and transparent with confidence!

Ultraviolet disinfection belongs to physical instant disinfection technology, which can keep sterile under the condition that the water body is not polluted. When the treated water leaves the disinfection reactor, Customized Breeding sterilization and disinfection equipment Some microorganisms killed by ultraviolet light will repair damaged molecules and regenerate bacteria under visible light irradiation, which is called light reactivation. Breeding sterilization and disinfection equipment manufactor Some bacteria can also repair themselves under the condition of no light, that is, dark reactivation. According to the current research results, photoreactivation is the main way of most microbial remediation and also the main control target.

Microwave electrodeless ultraviolet sterilization equipment has high value in microwave ultraviolet water treatment equipment, Customized Breeding sterilization and disinfection equipment It destroys and changes the structure of DNA of microorganisms through the irradiation of ultraviolet light, so that the bacteria will die immediately or cannot reproduce, so as to achieve the purpose of sterilization. The real bactericidal effect is UVC ultraviolet, Breeding sterilization and disinfection equipment manufactor Because C-band ultraviolet light is easily absorbed by the DNA of organisms, the ultraviolet light of about 253.7 nm is preferred. It is a pure physical disinfection method, which has the advantages of simplicity, convenience, broad-spectrum, no secondary pollution, convenient management and automation. With the introduction of various new designed ultraviolet lamps, the application range of ultraviolet sterilization is also expanding.

UV disinfection is generally only used for air and instrument surface disinfection. Surgical dressings cannot be treated by UV radiation as a routine method. Ultraviolet radiation is the general term of radiation in electromagnetic spectrum with wavelength from 10nm to 400nm, which can not cause people's vision. In 1801, German physicist Ritter found that the ultraviolet ray could sensitize the photographic negative containing silver bromide at the outer part of the ultraviolet end of the sunlight spectrum, so he found the existence of ultraviolet ray. Too much ultraviolet rays entering the body will cause skin cancer. Customized Breeding sterilization and disinfection equipment It can be disinfected after use every day. It should be disinfected two or three times a week. It is recommended that the toothbrush head should be replaced every three months. It can be disinfected every day. The SEGA toothbrush sterilizer I selected should be disinfected for 6-8 minutes each time. It is a good ultraviolet disinfection lamp. It needs to be equipped with a ballast. Mould formation is due to long-term lack of ventilation and humidity, Breeding sterilization and disinfection equipment manufactor If ventilation and moisture removal are available, mold will not grow. Since mold has been formed, first kill it with a mold remover, and then put a moisture bag such as a charcoal bag. I often do on-site mildew and odor removal projects. You can sprinkle lime on the corner of the wall or place charcoal in the house to absorb moisture when the house is wet. In addition, don't open the window in foggy or rainy weather. Open the window in good weather to ventilate in time.