According to different lamp tubes, ultraviolet sterilization lamps have thermal cathode low-pressure mercury vapor discharge lamps and cathode low-pressure mercury vapor discharge lamps; The hot cathode low-pressure mercury vapor discharge lamps can be divided into straight type, H-type, U-type tube, etc. from the appearance; Customized Microwave drying equipment For different needs, it can be divided into low (no ozone), ozone, high ozone, etc. The portable microwave electrodeless ultraviolet sterilization equipment can be used for close mobile irradiation, and the ultraviolet lamp suspension irradiation can also be used. Small articles can be irradiated in the ultraviolet disinfection box. Different kinds of microorganisms have different sensitivity to ultraviolet rays. When using ultraviolet rays for disinfection, the radiation dose must be used to reach the radiation dose required to kill the target microorganisms. Microwave drying equipment Price The product of the irradiation intensity and irradiation time of the ultraviolet lamp used for irradiation dose at the surface of the irradiated object. Therefore, according to the irradiation intensity of the ultraviolet light source, the required irradiation time can be calculated.
Application industry: It is applicable to odor control in municipal sewage, sewage pump station, garbage treatment plant (station), petroleum and petrochemical industry, pharmaceutical and chemical industry, food processing, spraying, printing prevention, leather processing and other production industries.
1. If linear installation is required, please use the installation method of low water inlet and high water outlet to slow down the water flow rate and increase the effect of ultraviolet radiation. 2. When working, Microwave drying equipment Price Do not look directly into your eyes with an ultraviolet lamp. When the equipment is open, repeated opening and closing will seriously affect the service life of the lamp. 3. If the water flow is too fast, please install current limiting and pressure limiting devices. 4. If the turbidity of raw water exceeds 5 degrees, a prefilter should be installed to ensure ultraviolet sterilization. 5. Please take out the quartz sleeve every time. Customized Microwave drying equipment After using the disinfection lamp for two to three months, check the surface for dirt to determine the next time to clean the surface of the quartz sleeve.
The gas of organic matter discharged from the workshop is subject to particle filtration and desorption after adsorption, and the high concentration organic waste gas from desorption is discharged after catalytic combustion. (The desorbed high concentration organic waste gas enters the catalytic chamber for catalytic combustion after heat exchange, and the discharged hot air desorbs and regenerates the adsorption bed and circulates in turn).
Compared with traditional water disinfection methods such as chlorine disinfection, Customized Microwave drying equipment Microwave electrodeless ultraviolet sterilization equipment is relatively safe and environmentally friendly. Chlorine agent is used for disinfection. When chlorine kills germs in water, due to its strong oxidation, it reacts with natural organic substances in water and generates disinfection by-products such as trichloromethane and haloacetic acid, Microwave drying equipment Price They all have potential carcinogenicity and certain mutagenicity to human body. Trichloromethane is also classified as Category 2B carcinogen in the list of carcinogens published by the International Cancer Research Institute of the World Health Organization, which poses a health threat of carcinogenicity, teratogenicity and mutagenicity.
The trapezoidal structure made of food grade transparent silica gel and special mold is used to prevent water leakage caused by improper installation. Microwave drying equipment Price UV irradiation intensity sensor/UV irradiation intensity monitor: The UV irradiation intensity sensor can monitor the output intensity of the UV disinfection system in real time online, and output mixed signals of 0-5V or 4-20mA for use by the monitor. Customized Microwave drying equipment The ultraviolet radiation intensity monitor receives the signal provided by the sensor, and can set the radiation intensity alarm value and lamp life according to the requirements. Monitor the system in real time to ensure the normal operation of the equipment.
