During the installation of the microwave and ultraviolet water treatment equipment, the commissioning shall be carried out continuously, production Microwave drying equipment A lot of work needs to be completed before installation. For example, some of their installations must meet the final installation standards and have the final acceptance standards, so that there can be more ways to deal with it, Microwave drying equipment manufactor The operation shall be carried out according to the relevant design requirements as far as possible, and all operations can be accepted during the operation process, so as to ensure the actual use.

With the extension of the use time of the clean microwave ultraviolet water treatment equipment, it is a normal phenomenon that the water production decreases. The decrease of water production in winter is due to the decrease of water temperature and permeability, and the change of reverse osmosis membrane density. These two reasons will reduce the water production of microwave and ultraviolet water treatment equipment. Strengthen pretreatment device, production Microwave drying equipment Increasing the cleaning time, replacing the filter element frequently, backwashing the reverse osmosis membrane in time, and extending the interval are all ways to promote the normal operation of the microwave ultraviolet water treatment equipment. Microwave drying equipment manufactor If the water pipe or microwave ultraviolet water treatment equipment is frozen, the valve shall be closed in time, wrapped with towel, and slowly watered with warm water. Do not directly use fire for barbecue, nor use boiling water for heating, so as to prevent the microwave and ultraviolet water treatment equipment and pipes from cracking, or use a hair dryer to dry them. At the same time, gently tap hard objects on the water pipe until the pipe freezes and thaws, and the tap water flows out smoothly. If the fully automatic frequency conversion water supply equipment has been frozen, it can only be wrapped with a hot towel and sprinkled with warm water until the pipe freezes and thaws, so that the water can flow out smoothly.

1. The welding of equipment shell and framework shall be firm without obvious deformation or burn through defects. 2. The equipment surface shall be evenly sprayed with the same color, and the surface shall be free of flow marks, bubbles, paint leakage and peeling. 3. The appearance of the equipment shall be neat and beautiful without obvious hammer marks and unevenness. The panel instruments, switches, indicator lights and labels shall be installed firmly and correctly. In order to ensure the stability of the equipment, we need to replace the lamp regularly, production Microwave drying equipment The imported lamp should be replaced after 9000 hours of continuous service or one year to ensure a high disinfection rate. Microwave drying equipment manufactor When replacing the lamp tube, first pull out the power socket of the lamp tube, pull out the lamp tube, then carefully insert the cleaned new lamp tube into the sterilizer, install the gasket, check for water leakage, and then plug in the power supply. Be careful not to touch the quartz glass of the new lamp tube with your fingers, otherwise the disinfection effect will be affected due to stains.

Microwave electrodeless ultraviolet sterilization equipment has high value in microwave ultraviolet water treatment equipment, production Microwave drying equipment It destroys and changes the structure of DNA of microorganisms through the irradiation of ultraviolet light, so that the bacteria will die immediately or cannot reproduce, so as to achieve the purpose of sterilization. The real bactericidal effect is UVC ultraviolet, Microwave drying equipment manufactor Because C-band ultraviolet light is easily absorbed by the DNA of organisms, the ultraviolet light of about 253.7 nm is preferred. It is a pure physical disinfection method, which has the advantages of simplicity, convenience, broad-spectrum, no secondary pollution, convenient management and automation. With the introduction of various new designed ultraviolet lamps, the application range of ultraviolet sterilization is also expanding.

Stainless steel wire woven filter screen is often used, 30-40 hole/cm filter screen is used for crude oil filtration, and 140-180 hole/cm filter screen is used for decolorization oil filtration. production Microwave drying equipment The selection of filter medium will affect the clarification of filtered oil and fat, and whether the cake unloading is smooth. The filter media used in the grease industry are mostly woven media, Microwave drying equipment manufactor Common cotton fabrics such as canvas, twill and ordinary white muslin with 20 yarns and 5-8 strands.

UV disinfection is an efficient, non organic chemical way to prevent mildew, production Microwave drying equipment The maintenance is low-cost and pollution-free. As a purely physical disinfection method, the microwave electrodeless ultraviolet sterilization equipment can not only reasonably remove most of the microbial strains in the water. Moreover, it is not easy to cause all disinfection and combustion products, thus ensuring that the level of microbial strains in tap water points is within the required product quality standards, Microwave drying equipment manufactor The microwave electrodeless ultraviolet sterilization equipment has the advantages of simplicity, convenience, broad-spectrum, high efficiency, pollution-free, convenient management and automation technology.