1. If linear installation is required, please use the installation method of low water inlet and high water outlet to slow down the water flow rate and increase the effect of ultraviolet radiation. 2. When working, Ultraviolet sterilization equipment manufactor Do not look directly into your eyes with an ultraviolet lamp. When the equipment is open, repeated opening and closing will seriously affect the service life of the lamp. 3. If the water flow is too fast, please install current limiting and pressure limiting devices. 4. If the turbidity of raw water exceeds 5 degrees, a prefilter should be installed to ensure ultraviolet sterilization. 5. Please take out the quartz sleeve every time. new type Ultraviolet sterilization equipment After using the disinfection lamp for two to three months, check the surface for dirt to determine the next time to clean the surface of the quartz sleeve.

The power supply is the foundation and should be used carefully. Generally, it needs to work under 200V/50Hz AC power, new type Ultraviolet sterilization equipment In order to ensure the correct operation of the complete set of automatic water softening device. Ultraviolet sterilization equipment manufactor The manufacturer of the microwave and ultraviolet water treatment equipment shall ensure that the power cannot be cut off, and that the switch of the equipment cannot be cut to the point, so as to prevent the quality problems of the softening microwave and ultraviolet water treatment equipment and the increase of equipment loss.

It is widely used in painting waste gas, pharmaceutical waste gas, breeding waste gas, chemical waste gas, feed waste gas, lampblack waste gas, printing waste gas, sewage waste gas, medicine, universities and research institutes and other laboratories

In the microwave and ultraviolet water treatment equipment, the reverse osmosis equipment needs three kinds of sealing rings to realize the sealing barrier of each part of the membrane shell. In order to reduce the resistance of the device, water or glycerin should be added to the surface of the sealing ring. new type Ultraviolet sterilization equipment Microwave ultraviolet water treatment equipment PP cotton softening equipment. Ultraviolet sterilization equipment manufactor Special attention should be paid to the use of petroleum jelly or other petroleum grease lubricants as lubricants. Otherwise, the fresh water pipeline will crack, especially the expansion of the sealant ring. The expansion of the skirt does not directly affect the operation of the system, but will affect the reloading of the system after unloading, that is, the expansion skirt is difficult to enter the slot during loading.

After years of development, microwave electrodeless UV sterilization equipment has been widely used in drinking water, food, beverages, electronic products, chemicals, medicine, sewage microwave UV water treatment equipment and other fields. Ultraviolet sterilization equipment manufactor High intensity odorless UV germicidal lamp is used to simplify the special stainless steel inner wall, so that the pretreated water has enough UV when passing through the UV. new type Ultraviolet sterilization equipment Irradiation has good sterilization effect. In addition, it has the advantages of simplicity, convenience, broad-spectrum, no secondary pollution, convenient management and automation.

What are the common faults of microwave and ultraviolet water treatment equipment, new type Ultraviolet sterilization equipment Leakage in the water pressure drop equipment system, lack of pressure at the inlet of the high-pressure pump, air leakage, water leakage, blockage of the filter element of the precision filter, high-pressure pump fault, etc. may cause the water pressure drop of the equipment. Solution: Overhaul the high-pressure pump and precision filter, and eliminate problems. Ultraviolet sterilization equipment manufactor The increase of equipment water pressure may be due to the error of high-pressure pump outlet scheduling index and the blockage of the pipeline from high-pressure pump to reverse osmosis equipment. Solution: recover the equipment pressure by dispatching the outlet index of the high-pressure pump and cleaning the pipeline between the high-pressure pump and the reverse osmosis equipment. The decrease in water production of the manufacturers of microwave and ultraviolet water treatment equipment may be due to the lower water temperature, lower water pressure, and pollution and blockage of the reverse osmosis membrane. Solution: recover normal production by adjusting the temperature of raw water and cleaning and replacing the reverse osmosis membrane.