1. The welding of equipment shell and framework shall be firm without obvious deformation or burn through defects. 2. The equipment surface shall be evenly sprayed with the same color, and the surface shall be free of flow marks, bubbles, paint leakage and peeling. 3. The appearance of the equipment shall be neat and beautiful without obvious hammer marks and unevenness. The panel instruments, switches, indicator lights and labels shall be installed firmly and correctly. In order to ensure the stability of the equipment, we need to replace the lamp regularly, production Microwave drying of nuts The imported lamp should be replaced after 9000 hours of continuous service or one year to ensure a high disinfection rate. Microwave drying of nuts manufactor When replacing the lamp tube, first pull out the power socket of the lamp tube, pull out the lamp tube, then carefully insert the cleaned new lamp tube into the sterilizer, install the gasket, check for water leakage, and then plug in the power supply. Be careful not to touch the quartz glass of the new lamp tube with your fingers, otherwise the disinfection effect will be affected due to stains.

The power supply is the foundation and should be used carefully. Generally, it needs to work under 200V/50Hz AC power, production Microwave drying of nuts In order to ensure the correct operation of the complete set of automatic water softening device. Microwave drying of nuts manufactor The manufacturer of the microwave and ultraviolet water treatment equipment shall ensure that the power cannot be cut off, and that the switch of the equipment cannot be cut to the point, so as to prevent the quality problems of the softening microwave and ultraviolet water treatment equipment and the increase of equipment loss.

With the extension of the use time of the clean microwave ultraviolet water treatment equipment, it is a normal phenomenon that the water production decreases. The decrease of water production in winter is due to the decrease of water temperature and permeability, and the change of reverse osmosis membrane density. These two reasons will reduce the water production of microwave and ultraviolet water treatment equipment. Strengthen pretreatment device, production Microwave drying of nuts Increasing the cleaning time, replacing the filter element frequently, backwashing the reverse osmosis membrane in time, and extending the interval are all ways to promote the normal operation of the microwave ultraviolet water treatment equipment. Microwave drying of nuts manufactor If the water pipe or microwave ultraviolet water treatment equipment is frozen, the valve shall be closed in time, wrapped with towel, and slowly watered with warm water. Do not directly use fire for barbecue, nor use boiling water for heating, so as to prevent the microwave and ultraviolet water treatment equipment and pipes from cracking, or use a hair dryer to dry them. At the same time, gently tap hard objects on the water pipe until the pipe freezes and thaws, and the tap water flows out smoothly. If the fully automatic frequency conversion water supply equipment has been frozen, it can only be wrapped with a hot towel and sprinkled with warm water until the pipe freezes and thaws, so that the water can flow out smoothly.

I. Efficient deodorization II. No substances need to be added III. Strong adaptability IV. Low operation cost V. No treatment VI. Small area of equipment VII. Manufacturing of high-quality imported materials

The sterilization principle of microwave electrodeless ultraviolet sterilization equipment is to use the sterilization ability of ultraviolet light. Can ultraviolet light directly kill microorganisms? Microwave drying of nuts manufactor According to different biological effects, ultraviolet light is generally divided into four parts according to wavelength: A-band (UV-A), production Microwave drying of nuts Also known as black spot effect ultraviolet (400 ～ 320 nm); B band (UV-B), also known as erythema effect ultraviolet (320 ～ 275 nm); C-band (UV-C), also known as sterilization ultraviolet (275 ～ 200 nm); D-band (UV-D), also known as vacuum ultraviolet ray (200-100 nm). C-band ultraviolet light is mainly used for water disinfection.

The microwave ultraviolet water treatment equipment uses quartz sand filter material to remove the suspended solids, sediment, impurities, etc. of larger particles in the raw water and the turbidity of precipitation. In addition, it can also remove many organic substances, bacteria, x, etc. in the water with the decrease of turbidity, and create a good condition for disinfection after filtration. production Microwave drying of nuts Use the adsorption capacity of activated carbon to effectively adsorb organic matter, free residual chlorine, colloid, particles, microorganisms Microwave drying of nuts manufactor For some metal ions and decolorization, the exchange function of ion resin is used to remove calcium and magnesium ions in raw water to avoid the impact of scaling on subsequent equipment. However, the operation is laborious and material consuming. Now, the dosing system is used to directly add scale inhibitor.