Breeding sterilization and disinfection equipment characteristic

1. It can quickly and effectively kill all kinds of bacteria, viruses and other microorganisms.

2. Through photolysis, it can effectively degrade chlorides in water.

3. Simple operation and convenient maintenance.

4. Small floor area and large water treatment capacity.

5. No pollution, strong environmental protection, no toxic and side effects.

6. Low investment cost, low operation cost and convenient equipment installation.

7. The unique inner wall treatment process is designed based on the optical principle, so that the cavity can make greater use of ultraviolet ray, and the sterilization effect is doubled.

breed Sterilization equipment It has many advantages, such as good light conditions, low energy consumption, thorough sterilization, and flexible installation of equipment. Not only that, the beautiful appearance also attracts many manufacturers to buy.

Breeding sterilization Precautions for use of equipment

Ultraviolet germicidal lamp should pay attention to the decline of the radiation intensity of the lamp tube. After using it for a period of time, we still use the fluorescent lamp concept to evaluate the lamp tube, and judge the invisible light intensity by the intensity of the visible light. This method is prone to errors, which will affect the germicidal effect. It should be judged from the following aspects.

1. Each microbe has its own specific UV killing and death dose standard, and K (sterilization dose)=I (irradiation intensity) X T (irradiation time). From the formula, the effect of high intensity for short time is the same as that of low intensity for long time. Therefore, the disinfection time should be lengthened after the lamp declines (after a long time of use) to ensure the disinfection quality.

2. The penetration ability of ultraviolet rays is not as high as expected. Any paper, plastic, ordinary glass, etc. will significantly reduce their radiation intensity. Therefore, the lamp tubes and glass sleeves should be kept clean (75% alcohol is often used to wipe them. If there are hard (calcium or magnesium) substances, iron or manganese in the water, then the quartz tubes need to be cleaned regularly. After cleaning the quartz tube, you should wear special plastic gloves to carefully load the quartz tube into the reactor. After installing the sealing ring, you should check whether there is water leakage. Plug in the power supply to ensure that the detection light is stable. If the water quality in the place of use is relatively turbid, turbidity ≥ 5 degrees, you should add treated methods such as flocculation, sedimentation, filtration, etc. to remove various impurities in the water, otherwise the sterilization effect will be greatly reduced.