Microwave electrodeless ultraviolet sterilization equipment Before installing the equipment, please measure the voltage of the equipment point and keep it within 180V-230V to ensure that the lamp ballast works normally. When installing the main reactor equipment, at least one side of the left and right sides should have a space of about 1.5m to facilitate the equipment UV lamp and quartz sleeve.    

Microwave Electrodeless ultraviolet sterilization equipment Put the main reactor equipment on the ground or foundation indoor for easy operation. The ground or foundation is necessary to be flat. Pipes, pipe fittings, valves, etc. at the inlet and outlet of equipment of various specifications, equipment quartz sleeves, take off the power protection cover, unscrew the fixing nuts, and slowly insert the equipment quartz sleeves one by one along the axis of the reactor, And put the attached O-ring rubber seal around 10mm away from the quartz pipe orifice.     

Screw down the fixing nuts. After the quartz casing equipment is completed, insert the lamp into the quartz casing. Connect the lamp with the ceramic lamp holder with the lamp holder, and the other end with the ballast. Overcurrent microwave is electrodeless Ultraviolet sterilization equipment Steps for equipment and commissioning of over-current ultraviolet sterilizer: before equipment, please measure the voltage at the equipment point and keep it within 180V-230V to ensure that the lamp ballast works normally.