Breeding sterilization and disinfection equipment The module is installed in the open UV disinfection channel. For the convenience of repair, the power distribution cabinet and control cabinet are installed above the channel. The UV light tube rack is arranged in the middle, and the UV light tube is parallel to the water flow direction! Type UV disinfection equipment shall include: UV lamp module group, module support, power distribution center.     

The system control center, water level exploration and control output are composed. The module structure of the ultraviolet sterilizer is designed with low resistance according to the principle of fluid mechanics, which reduces the impact of water flow on the module to a minimum, which can effectively avoid the reduction of the impact of water flow resistance on the lamp tube and cleaning system, and better protect the lamp tube. The air driven rodless cylinder is used for active cleaning of the lamp tube. A single cleaning head is used to clean the casing at one time, leaving no dead space. After cleaning, the cleaning head is parked at the end of the casing where there is no ultraviolet light output, which will not hinder the disinfection of ultraviolet light, and can play a better role in sterilization. In the process of active cleaning, the system can operate normally, and the disinfection effect is not affected, (The new cleaning system can effectively improve the unstable cleaning and lamp tube damage of existing products on the market due to structural reasons.) According to the change of water level, this UV disinfection system can actively close the lamp tube above the water level to avoid unnecessary damage caused by the long-term lighting of the lamp tube when there is no water.

breed Sterilization equipment In order to achieve the same disinfection effect at low water level without changing the power of a single lamp, it can not only save energy, but also enable the irradiation energy to reach the required dose. When the water level rises, it will take the initiative to turn over the corresponding lamp. The type ultraviolet sterilizer is also called the frame type ultraviolet sterilizer: odorless ultraviolet sterilization lamp, and the inner wall of the cylinder is made of specially processed food grade 304 stainless steel. The pretreated water will be illuminated by the ultraviolet ray of 253.7 nm wavelength when passing through the cylinder, which has outstanding bactericidal effect. Since it does not change the physical and chemical properties of the water, it is an indispensable excellent equipment in the fields of electronics, medicine, food, chemical industry, etc. The ultraviolet sterilizer does not produce any secondary pollutants. Due to the new disinfection technology in the world, it has the advantages of high efficiency, broad-spectrum, low cost, long life, large amount of water, pollution-free and other disinfection methods that cannot be compared with other disinfection methods. At present, it has gradually become a mainstream disinfection method in western developed countries. The device strategy of type UV sterilizer: take out all the accessories and check them, first install the sealing sleeve at the open end of the quartz tube as shown in the figure, Install the quartz tube into the stainless steel shell, and then install the sealing ring on the quartz tube.